PVP/VA Bed adhesion powder

As a newbie using secondhand Ender3 printers I'm learning as I go. This PVP/VA powder has been fantastic & I haven't had a failure due to poor bed adhesion since starting to use this & as a bonus it washes off so easily. I use the Ghetto Goop as an application tool as I find it easier to spread the solution that I spray on. I sometimes add an extra layer if I think the previous print took up a large area on the build plate.

I would not recommend that you order more than 1 unit of this at a time - I ordered 4 and it all arrived in a single 20g lot. Great if I was making up a couple of litres in a single container, but a right 'PITA' for making up 500ml at a time.
Normal kitchen scales struggle to measure out 5gms at a time and the mess it can leave trying to get it out of the 'bulk' pack is a challenge to clean up as the powder is so fine.
As for its adhesion qualities I'm just about to try it for the first time

It work i have a spray bottle by all my printers

I got this as I was having issues with 1st layer adhesion with PC. Filament was dried, used gluesticks, nothing worked. Sides were lifting, stringiness here and there. Gave this a mix with IPA and water and I'll let the results speak for itself. A must have for PC for me.

I followed the instructions and it produced a great product. Things stick to the build plate and come off easily whenit cools down. And it lasts as you only use a very small amount. It is also a lot cheaper than the other ones. It alsodoesnt leave marks on the print base.