Customer Reviews
I had to spend a day today to get this working as it's my first time using ASA. I think it might be just ASA but my generic settings with the K1 max did not work. I used 245 deg C print temp. I had to increase the extrusion rate(flow ratio) to 1.036 from 0.926. That's 11% up from default. I had to make sure inner and outer brim was set (misicilaneous settings) and still everynow and then the stick to the bed is not enough. When the k1 really got moving the fillament would just tear. I could see this in some of the later test runs after settting the temp and extrusion rate. The default volumetric speed setting for ASA on the K1 max is 14mm3/S. For this I needed to reduce it to 9mm3/s and it's now printing really well. Can't wait to try the pieces out. If there was a default setting setup they could give for the K1 it would be great.
This orange is bright and beautiful! Looks much better in person than the product photo. See review photo (also in photo is Fluro Yellow ABS)
The colour really stands out as it quite bright. Nice ABS to print with, no warping or layer adhesion problems. Good filament. BTW, it took less than 24 hrs to reach me (Melb) from pick up (Syd).